Smart entity doll instructions

The intelligent entity doll has temperature-controlled heating, which can simulate human voice.

First, temperature control heating

1. Insert the official AC power cord into the heating power port located 20 cm below the left side of the sex doll. After connecting the plug to the 220V household power supply, the controller will emit a beep and the screen will display the factory default. Set at 48 ° C, return to real-time temperature after 4 seconds. After the start, the surface of the doll has a thermal sensation around 30 minutes, and the body temperature is about 50 minutes. (Press "+" or "-" to set the heating temperature)

2, heat transfer from the inside of the doll, the interior is equipped with a temperature control probe, the hand, ankle, foot can not be directly heated. (Note: This product will not affect the life or damage the product within 60 °C. Please use the blanket to wrap the doll when heating, it is beneficial to warm up quickly. It can be kept for 5-6 hours after heating. Special reminder: please flatten the sex doll when heating Lying, hands and feet straight apart.)

3. When the red light is on, the doll starts to heat up, and the real-time temperature is displayed on the controller. At this time, the display temperature will rise slowly to reach the set temperature, then the power supply turns off and the green light is on, and the doll stops heating. When the temperature on the display drops by 5 degrees, the red light illuminates and the doll heats up again.

4. Display the real-time temperature when heating. When the display shows “Err”, it means that the heating wire or probe is not connected.

Second, you can speak

1, this product uses MP3 files, the sound is realistic, real people feel.

2, DC 5V charging, built-in 4.2V-200 mAh battery, use time 3-5 hours.

3, boot: long press the red button to make a drop, shut down: long press the red button to make two drops.

4. Short press the red button to increase the volume. Press the green button to decrease the volume. The volume is set to level 3. (This is the total volume control)

5. Press and hold the green button to adjust the next song. This is the next loop.

6. When the main switch is turned on, touching the chest or the lower body will make a sound. The length of the sound depends on the size of the downloaded content. The sound size varies from small to large according to the vibration intensity of the baby's chest and lower body. There are 7 levels. Stop shaking for 4 seconds and return to level 1, and continue to vibrate from small to large.

7, this product can independently download the sound of 4MB size. Press a loop key to play the selection. Touch single to play. (The company provides sound content, connect to the computer with the Android phone data cable to download)

8. The red and green button caps are installed according to the position of the figure.